EAS2DM1089
REMOVING THE FUEL HOSE
1. Disconnect:
• Fuel hose
Refer to "REMOVING THE FUEL TANK" on
page 7-2.
EAS26980
CHECKING THE FUEL INJECTOR
1. Check:
• Injector
Obstruction → Replace and check the fuel
pump/fuel supply system.
Deposit → Replace.
Damage → Replace.
2. Check:
• Injector resistance
Refer to "CHECKING THE FUEL INJEC-
TOR" on page 7-6.
EAS26990
CHECKING THE THROTTLE BODY
1. Check:
• Throttle body
Cracks/damage → Replace the throttle body.
2. Check:
• Fuel passages
Obstructions → Clean.
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Wash the throttle body in a petroleum-based
solvent.
Do not use any caustic carburetor cleaning
solution.
b. Blow out all of the passages with compressed
air.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS2DM1090
INSTALLING THE INTAKE MANIFOLD
1. Install:
• Intake manifold joint "1"
• Intake manifold "2"
TIP
Make sure that the projection "a" on the intake
manifold joint is facing down.
1
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
2
a
EAS2DM1091
INSTALLING THE FUEL HOSE
1. Install:
• Fuel hose
• Fuel hose connector cover
ECA2DM1039
NOTICE
When installing the fuel hose, make sure that
it is securely connected, and that the fuel
hose connector cover is in the correct posi-
tion, otherwise the fuel hose will not be prop-
erly installed.
TIP
• Wipe up any fuel remaining in the recess "a" in
the fuel pump with a dry rag "1".
• After installing the fuel hose connector cover
"2", make sure that it is installed securely.
▼▼▼
▲▲▲
EAS2DM1092
INSTALLING THE THROTTLE BODY
1. Install:
• Throttle body
TIP
Align the projection "a" on the throttle body with
the slot "b" in the throttle body joint.
7-6
THROTTLE BODY
1
a
2