Table of Contents
Advertisement
8 • Attaching the Decorative Clamps
12
Indentation
Steps 8-1 – 8-3
Hunter Fan Company
Your Hunter Fan comes with two decorative clamps. Each clamp
assembly is made up of two pieces.
8-1. Place the two halves of the lower clamp around the lower end of
the spindle and the motor adapter.
8-2. Insert two 3/8" screws into the indentations in the lower clamps.
Tighten completely.
8-3. Insert two 1/2" screws into the remaining holes in the lower
clamp. Tighten completely.
8-4. With the lower clamp in place, take both pieces of the upper
clamp and place them around the downrod and spindle.
8-5. Insert two 1/2" screws into the indentations in the upper clamps.
8-6. Insert two 3/8" screws into the remaining holes in the upper
clamp. Tighten completely.
Steps 8-4 – 8-6
1/2" Screw
3/8" Screw
41880-01 • 05/13/04
Advertisement
Table of Contents
