Table of Contents
Advertisement
OVERVIEW
This appliance is intended for professional use only.
Before using the appliance, the user must read this
instructions manual carefully and any other additional
information provided by Varian. Varian declines any
responsibility for total or partial non-compliance with the
instructions, improper use by untrained personnel,
unauthorized operations or use contrary to specific
national regulations.
Ion Pump HV P.S. is a power supply that is used to
power ion pumps during transportation phases in order
to prevent air entering the pump.
The power supply uses a 9V non-rechargeable battery
positioned inside or, alternatively, may be connected to
an external power source able to provide a DC voltage of
9 V with greater autonomy.
All the information required to guarantee operator
safety during use of the appliance is provided below.
Principle of operation
The unit is able to determine whether or not the pump
connected is active. When the HV is ON, the unit
measures pump current:
if the current is less than 50 nA, the discharge inside
the pump is OFF (red LED L1 blinking);
if the current exceeds 50 nA, the pump is operative
(green LED L2 blinking).
The unit generates the HV that powers the ion pump
when the power switch is set to ON.
ION PUMP HV P.S.
POWER SUPPLY UNIT INSTALLATION PROCEDURE
PREPARATION FOR INSTALLATION
The device is furnished in special protective packaging;
if there are any signs of damage to this packaging
during transport, contact your local sales office. When
unpacking the unit, take particular care to prevent any
yielding of the power supply and any impacts. Do not
dispose of the packaging in the environment. The
material is fully recyclable and complies with EC
Directive 85/399 for protection of the environment.
Packaging of the power supply
13/16
TECHNICAL INFORMATION
87-900-111-01 (C)
Advertisement
Table of Contents
