Parts - Lynx Sx - 3P; Replacing Tiller Charger Port Cover - Invacare LYNX Series Manual

PROCEDURE 8
This Procedure Includes the Following:
R
Replacing Tiller Charge Port Cover
E
P
L
A
After ANY adjustments, repair or service and
C
BEFORE use, make sure that all attaching hard-
E
ware is tightened securely - otherwise injury or
M
damage may occur.
E
N
Turn Power OFF and remove key from igni-
T
tion. Disconnect battery harness from the
motor lead.
P
A
R
REPLACING TILLER CHARGER
T
PORT COVER (FIGURE 1)
S
NOTE: Save the two (2) mounting screws and self-
locking nuts for reuse when installing the NEW tiller
charger port cover.
1. Remove the two (2) mounting screws and self-
locking nuts securing the tiller charger port cover
to the tiller assembly.
2. Remove the tiller charger port cover from the tiller
assembly.
L
Y
3. Align the mounting holes in the NEW tiller charger
N
port cover with the mounting holes in the tiller
X
assembly.
4. Secure the NEW tiller charger port cover to the
S
tiller assembly using the two (2) EXISTING mount-
X
3 ing screws and self-locking nuts. Securely tighten.
P
WARNING
REPLACEMENT PARTS - LYNX SX - 3P
Tiller
Charger
Port Cover
Mounting
Screws
FIGURE 1 - REPLACING TILLER CHARGER
PORT COVER
44 44
Self-locking
Mounting
nuts
Holes
Tiller
Assembly