Changing The Fuse In The Vehicle Power Cable; Mounting On Your Dashboard - Garmin nuLink! LIVE 2390 Owner's Manual

• Shorten the display timeout time
(page 64).
Changing the Fuse in the
Vehicle Power Cable
Notice
When replacing the fuse, do not lose
any of the small pieces and make
sure they are put back in the proper
position. The vehicle power cable
does not work unless it is assembled
correctly.
If your device does not charge in your
vehicle, you may need to replace the
fuse located at the tip of the vehicle
adapter.
1. Unscrew the end piece.
TIP: You may need to use a coin to
remove the end piece.
2. Remove the end piece, the silver
tip, and the fuse (glass and silver
cylinder).
nüLink! 2300 Series Owner's Manual
3. Install a 1 A fast-blow fuse.
4. Place the silver tip in the end piece.
5. Screw the end piece back into the
vehicle power cable.
Mounting on Your
Dashboard
Notice
The permanent mounting adhesive is
extremely difficult to remove after it is
installed.
Use the enclosed mounting disk to
mount your device to the dashboard
and comply with certain state
regulations.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the disk.
3. Place the disk on the dashboard.
Appendix
69