Table of Contents
Advertisement
• Insert the core probe in the product without forcing
excessively and close the door to start the cycle.
Make sure the tip (the sensitive part) is positioned. It is
important to place the core probe correctly near the center
of the product, making sure the tip does not protrude and, in
particular, that it does not touch the pan.
OK!
If the core probe is not inserted or is inserted wrongly, after
some minutes a pop-up window opens showing the
message the cycle is going to be driven by time in order to
not corrupt the process.
MANUAL
The probe is not inserted. The
cycle automatically changed
• At the end of the cycle, open the door and remove the core
probe, putting it back in its original position.
b
NOTE!
Remember that the pans are cold, therefore use
gloves
PRODUCT LOADING
It is advisable to keep food covered during the cycle in order to
facilitate chilling. The product must be evenly distributed inside
the compartment to ensure good air circulation and therefore
better preservation. In any case, do not leave the door open
longer than necessary when removing or loading food.
It is advisable to use shallow containers to allow good air
circulation around the product (the greater the surface area of
the food exposed to the cold air, the shorter the chilling time).
18
i
Probe not inserted
from probe to time.
a
Clean the containers and their support surfaces thoroughly to
avoid contaminating the food. It is also advisable to put the
food in the chiller using the same container it was cooked in.
NOTE!
The appliance can operated with MULTIPROBE
accessory (up to three independent probes) or
USB probe accessory. To enable the accessories
see chapter E.13 Settings mode.
Select the most appropriate probe and enter the core probe
temperature on the numeric keypad;
MANUAL
3
°C
1
1 2 3
Hard Chill
-
20
4
5
6
c
°
7
8
9
1:30
0
m:s
Adjustable PROBE to measure the product core
temperature
Adjustable PROBE for data transmission on USB
pendrive (accessory)
To enable USB probe accessory see chapter E.13
Settings mode.
MULTIPLE PROBE (accessory)
To enable Multiprobes accessory see chapter E.13
1
Settings mode.
How to use MULTIPLE PROBE accessory
• Touch probe icon.
A pop-up opens showing the list of all probes available.
MANUAL
1
1 2 3
-
4
7
1:30
• Select the required probe (for example probe A),
MANUAL
1
Chill
0
°C
Soft / Hard
01:30
:00
-
18
°C
Hard Chill
20
5
6
c
°
8
9
C
B
0
m:s
A
C
A
Advertisement
Table of Contents
