Epson Equity 4 User Manual page 99

Note
When the hard disk drive ribbon cable is positioned
correctly, the red wire on the cable is next to the power
supply connector on the hard disk drive, as shown above.
Make sure the holes in the cable connector fit over all the
pins in the hard disk drive connector; then push in the cable
connector.
If you do not correctly align the holes with the pins
could severely damage your hard disk drive when you
3. Locate one of the power supply cables that lead from the
power supply (behind the horizontal drive bays). The
power supply cables may be secured in a plastic band on
the side of the power supply. If so, unfasten the band to
loosen the cables.
The cables are labeled
one that is free. (If your drive requires a small power
supply connector, use
and
PA, PB, PC,
PD.)
Installing and Removing Drives
can use any
PD; you
3-27