Starting The Program - Epson Equity 4 User Manual

Starting the Program

Follow these steps to start the hard disk formatting program:
1. Insert the Reference diskette in drive A and log onto drive A.
2. Type HDFMTALL and press [Enbrl. You see the Hard Disk
Format Menu:
1 - Format
2 - Destructive surface analysis
3 - Non-destructive surface analysis
0 -
The option you choose depends on whether you are
formatting a new disk or reformatting a used disk. The
options work as follows:
it has no defective track table) and lets you decide
which tracks to mark as bad. Then it formats the disk
and marks the bad tracks so they are never used to
store data.
disk for read/write errors or unflagged bad tracks and
updates the defective track table. Because this option
writes and reads data on the disk, it destroys all data on
any track that produces an error. You cannot run this test
on a disk that has never been formatted.
disk for unflagged bad tracks without destroying data.
You
formatted.
5-2 Formatting a Hard Disk
Exit
surface analysis tests the entire
cannot run this test on a disk that has never been
analysis checks the