Exiting The Program - Epson Equity 4 User Manual

As the program checks each track, it decreases the cylinder
numbers to zero. When the test is complete, the program
displays a report on the status of the disk, such as the following:
Analysis
Count of tracks flagged bad
Count of tracks with read, verify errors =
Count of good tracks
No read, verify error was detected.
If the program finds errors, the screen displays a table of the
tracks that produced the errors. Then you see this message:
Press
Check the information displayed. Then press m to return to
the Hard Disk Format Menu.

Exiting the Program

To leave the Hard Disk Format Menu, select Exit. You see the
operating system command prompt.
If you formatted the hard disk or ran the Destructive surface
analysis option, you must now prepare your hard disk for use
with your operating system. See your operating system manual
for instructions.
finished.
to return to the menu.
ENTER
Formatting a Hard Disk
=
n
n
5-11