Using A Password; Changing Or Deleting A Password - Epson Equity 4 User Manual

Using a Password

If you set a System Access password when you ran the SETUP
program, you must enter it every time you turn
computer. Follow these steps to use your password:
1. If you do not have a hard disk, insert your system diskette
in drive A.
2. Turn on or reset the computer. You see the following prompt:
Enter Password:
Type your password. You see
3.
you type. Then press m
After you type the password correctly and press [bbr), the
computer loads
command prompt.
Note
If you do not know the correct password, see "Password
Problems" in Chapter 6.

Changing or Deleting a Password

To change or delete your password, you must run the SETUP
program and follow the instructions for entering a password in
Chapter 2 of the
If you do not know your password, see "Password Problems"
in Chapter 6.
operating system and displays the
the
Setup Guide.
on
asterisk for each character
an
Using Computer
Your
or reset the
1-23