Steps
1. Place the power-button into its slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power-button with the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) that secures power-button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the
base
cover.
3. Follow the procedure in
Power button with fingerprint reader
Removing the power-button with fingerprint reader
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
I/O
board.
About this task
NOTE:
This procedure is applicable only for computers that are shipped with a fingerprint reader on the power-button.
The following images indicate the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
56
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.