MULTIQUIP Mikasa Series Operation Manual page 13

Figure 2 shows the location of the basic controls and
components of the MVHeR60 Plate Compactor. The
function of each control is described below:
1. Guard Frame — Protects the components of the plate
compactor.
2. Battery Pack — Rechargeable Lithium Ion Battery.
3. Lifting Bale — When lifting of the compactor is
required either by forklift, crane, etc., tie rope or chain
around this lifting point.
4. Travel Lever — Push the lever forward, the compactor
will move in a forward direction, pull the lever
backwards, the compactor will move in backwards
direction. Placing the lever in the middle (midway) will
cause the compactor not to move (neutral).
5. Handle (Storing Position) — When operating the
compactor use this handle bar to maneuver the
compactor.
6. Breather Cap — Remove this cap to bleed (remove
air) the hydraulic system.
7. Handle (Working Position) — When operating
the compactor use this handle bar to maneuver the
compactor.
MVHeR60 COMPACTOR • OPERATION MANUAL — REV. #0 (02/09/22) — PAGE 13
8. Switch Box — contains buttons and indicators to
operate compactor.
9. Vibration Case — Encloses the eccentric, gears and
counter weights.
10. Power Indicator — Lights green when the power
button is pressed.
11. Power Button — Used to turn power on and off.
12. Alert Indicator — Lights orange to indicate something
is wrong with compactor.
13. Error Indicator — Lights red when an error is detected.
14. Start/Stop Button — Used to start and stop unit.
15. Vibrator Oil Gauge — Shows how much oil is in
vibration case..
16. Grip — Hold to control handle.
17. Water Tank (Optional) — Used when your application
requires sprinkling. Do not fill with diesel fuel or gasoline
as this creates both a safety and environmental hazard!
COMPONENTS