Sony Digital Wireless Generation 3 Manual page 9

SONY
SONY DWX
MULTI-CHANNEL SYSTEM SET UP (Without use of Wireless Studio Software)
ABOUT THE SONY DWX DIGITAL WIRELESS SYSTEM
Put the Tx into Pairing Mode by holding down the 'Minus' button whilst powering on the Tx. If using a DWM-02N
Handheld, make sure to assemble the handheld once in scanning mode. If the Tx is button-locked, simply take out
and reinsert the battery while holding the minus button. The Tx should show it is in pairing mode.
Tx
Power on whilst holding
the Minus (-) button
Once detected, the Receiver will display the Tx's it has picked up and are able to pair with. Select the Tx.
QL
PAIRING
(Transmitter Name)
RF
Repeat and pair all Tx's to an Rx channel.
If anything changes within the Network, e.g. IP addresses, you will need to re-pair the transmitters.
K
DWX
Digital Wireless Generation 3
AF/PEAK
ALERT
QL
PAIRING
PAIRING DONE
RF
Contact Karno Sound for 24hr support:
07747515123 | 07715103222 | 07732398619
Email : contact@karno.com
Power on side
QL
0
PAIRING
GET INFORMATION
-20
-36
-60
RF
BATT
ALERT
L
Tx 1
SCANNING...
+
POWER
-
ALERT
AF/PEAK
0
-20
-36
-60
BATT
AF/PEAK
0
-20
-36
-60
BATT
9.