|
Checking and Cleaning the Print Heads
10
Aligning the Print Head
Press
, press d to highlight
Menu
1.
Press d to highlight
2.
Select the paper configuration number for the loaded media, then press
3.
HEAD ALIGNMENT
4.
.
Menu
is highlighted. Press
BI-D ALL
5.
the alignment patterns.
Determine which pattern in each set has
6.
the smallest gaps in the lines. Press u or d
to select the number, then press
Repeat step 6 for the rest of the pattern
7.
sets, then press the Pause button to exit.
Checking and Cleaning the Print Heads
If your prints show a color shift or horizontal lines, check the print head nozzles for clogs or deflections. If
necessary, run a cleaning cycle.
Note:
You can set the printer to automatically check the nozzles periodically or before each print job using one of
the PRINT NOZZLE PATTERN options on the PRINTER SETUP menu. You can also run different head cleaning
levels and set up automatic cleaning cycles. See page 19 for instructions.
Press
, press d to highlight
Menu
1.
Select
NOZZLE CHECK
2.
Examine the printed pattern to determine if
3.
the print heads need cleaning.
If you need to clean the print heads, press and
4.
hold the
button for three seconds.
Menu
You may also want to align the print heads; see the
previous section for instructions.
PAPER SETUP
, then press
PAPER SETUP
is highlighted. Press
to print
.
TEST PRINT
, press
, and press
Menu
, and press
.
Menu
.
Menu
Aligned
Mis-aligned
pattern
patterns
, and press
again.
Menu
to print a nozzle check pattern.
Cleaning not needed
Clean the print heads
.