Step 1 Determine Location For Concrete Pad And Operator; Step 2 Concrete Pad And Operator Attachment - Chamberlain RSW12UL Installation Manual

Step 1 Determine Location for
Concrete Pad and Operator
Compact Installation Only
DO NOT run the operator until instructed.
Refer to the illustration to determine the measurements and location of
the concrete pad.
NOTE: When lifting the operator use the handle to avoid damaging the
operator.
Step 2 Concrete Pad and Operator
Attachment
Compact Installation Only
CHECK the national and local building codes before installation.
NOTE: When lifting the operator use the handle to avoid damaging the
operator
1. Install the electrical conduit.
2. Pour a concrete pad (reinforced concrete is recommended). The
concrete pad should be 6 inches (15.2 cm) above the ground and
deeper than the frost line. Ensure the pad is tall enough to avoid
possible flooding.
3. Secure the operator to the concrete pad with appropriate fasteners.
NOTE: An alternative to a concrete pad is to post mount the operator, see
Accessories.
5.5" (14 cm)
4.5" (11.4 cm)
Conduit Location
4" (10.1 cm)
1" (2.5 cm)
6.5"
(16.5 cm)
Conduit
1.5"
10" (25.4 cm)
(3.8 cm)
15" (38.1 cm)
24" (61 cm)
Mounting Footprint
13.6" (34.5 cm)
12.2" (31 cm)
2.5"
6.1"
(6.3 cm)
(15.5 cm)
(35.6 cm)
Pad
14.8" (37.6 cm)
Cover Mounting Distance
APPENDIX
Gate Hinge Center
Gate Open
90°
3
4 Concrete
Anchors
1/2" x 3 1/2"
1
28"
14"
(71.1 cm)
41
TOP VIEW OF OPERATOR AND GATE
NOTE: There should only be a
maximum of 4" (10.2 cm) from the
center of the hinge to the edge of the
4" (10.2 cm) maximum
post or column. If the distance is
greater than 4" (10.2 cm) entrapment
protection for this area is required.
Output Shaft Center
26-1/2" (67.3 cm)
9"
(22.8 cm)
24"-32" (60.9-81.2 cm)
24" (60.9 cm)
6" (15.2 cm)
Above Ground
2
24"
(61 cm)
28"
(71.1 cm)
Post Mount
Below the frost line.
Check all national
and local codes.