Enter Manual Setup Mode; Reversal Force Dial; Set The Limits - Chamberlain RSW12UL Installation Manual

Residential dc vehicular swing gate operator

Hide thumbs Also See for RSW12UL:

Table of Contents

Enter Manual Setup Mode

NOTE: For dual gate applications, the limits will have to be set for

each operator. The gate MUST be attached to the operator before

setting the limits and force. Disconnect biparting gates before

setting limits. Pay special attention if magnetic locks are installed.

NOTE: While setting the Limits, all entrapment protection devices will be

disconnected, and the Remote Control buttons can be used to move the

gate as needed. During the Automatic Force Setup, all entrapment

protection devices will be reconnected, and the gate will automatically

open and close.

To enter manual set up mode, make sure that both SET OPEN and

SET CLOSE LEDs are flashing. If they are not flashing, press and

release both the SET OPEN and SET CLOSE buttons.

The REVERSAL FORCE DIAL is set to minimum at the factory. You

will be able to adjust the force setting after the initial Manual Setup.

Once initial limits have been set, the REVERSAL FORCE dial on the

Control Board is used to fine tune the force where wind or

environmental changes may affect the gate travel. See Fine Tune the

Force below.

All Settings 1-10: Automatically increase the force due to gate wear

or temperature changes

Press and hold the MOVE GATE buttons to jog the gate to the

desired OPEN position. Release the MOVE GATE button when the

desired OPEN limit is reached.

Press and release the SET OPEN button to save the limit.

Press and hold the MOVE GATE buttons to jog the gate to the

desired CLOSE position. Release the MOVE GATE button when the

desired CLOSE limit is reached.

Press and release the SET CLOSE button to save the limit.

Upon successfully setting the limits for your gate setup, the Manual

Setup Mode will exit.

ADJUSTMENT

Table of Contents