Epson Stylus Photo RX500 User Manual page 114

6. Insert the new cartridge into the holder. Press down firmly until it clicks into
place.
If you need to replace other ink cartridges, repeat steps 4 through 6 before
continuing with step 7.
7. Close the cartridge cover. (It should click into place.)
Caution:
If you find it difficult to close the cover, make sure all the cartridges are firmly
seated. Press down on each newly installed cartridge until you hear it click into
place. Do not attempt to force the cover closed.
8. Lower the scanner unit.
The RX500 begins charging the ink delivery system and
the LCD screen. Wait for the message to disappear before using the RX500.
Caution:
Never turn off the RX500 while Charging appears on the LCD screen, unless it
hasn't moved or made noise for more than 5 minutes. This may cause incomplete
charging of the ink.
Note:
Ink charging uses ink, so it's best to install new ink cartridges or used cartridges
with a relatively high level of ink. Used cartridges with little ink remaining may
become empty immediately after being installed.
114
Maintaining the RX500
appears on
Charging