Trane Symbio 700 Controller Application Manual page 2

Introduction
Read this manual thoroughly before operating or servicing this unit.
Warnings, Cautions, and Notices
Safety advisories appear throughout this manual as required. Your personal safety and the proper
operation of this machine depend upon the strict observance of these precautions.
The three types of advisories are defined as follows:
Proper Field Wiring and Grounding Required!
Failure to follow code could result in death or serious injury.
All field wiring MUST be performed by qualified personnel. Improperly installed and grounded
field wiring poses FIRE and ELECTROCUTION hazards. To avoid these hazards, you MUST
follow requirements for field wiring installation and grounding as described in NEC and your
local/state/national electrical codes.
Personal Protective Equipment (PPE) Required!
Failure to wear proper PPE for the job being undertaken could result in death or serious injury.
Technicians, in order to protect themselves from potential electrical, mechanical, and chemical
hazards, MUST follow precautions in this manual and on the tags, stickers, and labels, as well
as the instructions below:
•
•
•
©2022
Indicates a potentially hazardous situation which, if not avoided, could result in death or
WARNING
serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in minor or
CAUTION
moderate injury. It could also be used to alert against unsafe practices.
Indicates a situation that could result in equipment or property-damage only accidents.
Before installing/servicing this unit, technicians MUST put on all PPE required for the
work being undertaken (Examples; cut resistant gloves/sleeves, butyl gloves, safety
glasses, hard hat/bump cap, fall protection, electrical PPE and arc flash clothing).
ALWAYS refer to appropriate Safety Data Sheets (SDS) and OSHA guidelines for proper
PPE.
When working with or around hazardous chemicals, ALWAYS refer to the appropriate SDS
and OSHA/GHS (Global Harmonized System of Classification and Labelling of Chemicals)
guidelines for information on allowable personal exposure levels, proper respiratory
protection and handling instructions.
If there is a risk of energized electrical contact, arc, or flash, technicians MUST put on all
PPE in accordance with OSHA, NFPA 70E, or other country-specific requirements for arc
flash protection, PRIOR to servicing the unit. NEVER PERFORM ANY SWITCHING,
DISCONNECTING, OR VOLTAGE TESTING WITHOUT PROPER ELECTRICAL PPE AND
ARC FLASH CLOTHING. ENSURE ELECTRICAL METERS AND EQUIPMENT ARE
PROPERLY RATED FOR INTENDED VOLTAGE.
WARNING
WARNING
ACC-APG002A-EN