Samsung AC BXAP G Series Installation Manual page 8

Installation Procedure
CAUTION
• This device must be installed according to the national
electrical rules.
• If your outdoor unit exceeds a net weight of 60 kg, do
not install it on a suspended wall, but stand it on a floor.
• When installing the outdoor unit at the seaside, an
additional protective coating (third party) may be
required. Make sure that it is not directly exposed to
sea breeze. If you cannot find an adequate place free
from direct sea breeze, construct a protection wall or a
protective fence.
– Install the outdoor unit in a place (such as near buildings
etc.) where it can be prevented from sea breeze. Failure
to do so may cause a damage to the outdoor unit.
Sea breeze
Sea
Outdoor Unit
• If you cannot avoid installing the outdoor unit at the seaside,
construct a protection wall around to block the sea breeze.
• Construct a protection wall with a solid material such
as concrete to block the sea breeze. Make sure that the
height and the width of the wall are 1.5 times larger
than the size of the outdoor unit. Also, secure a space
larger than 700 mm between the protection wall and
the outdoor unit for exhausted air to ventilate.
Sea breeze
Sea
CAUTION
• In areas with heavy snow fall, piled snow could block the air
intake. To avoid this incident, install a frame that is higher
than estimated snow fall. In addition, install a snow-proof
hood to avoid snow from piling on the outdoor unit.
Snow-proof hood
Estimated
snow fall
Frame
Ground
8 English
Sea breeze
Sea
Outdoor Unit
Outdoor Unit
Protection wall
CAUTION
• Depending on the condition of power supply, unstable
power or voltage may cause malfunction of the parts
or control system. (At the ship or places using power
supply from electric generator...etc)
• Install the unit in a place where water can drain smoothly.
• If you have any difficulty finding installation location as
prescribed above, contact your manufacturer for details.
• Be sure to clean the heat exchanger and base plate of the
outdoor unit regularly from any collected sand and salt.
Touch up the additional protective coating (third party)
if needed, at least once in a year or according the third
party's product requirements.
• Check the condition of the product periodically.
– Check the installation site every 3 months and
perform anti-corrosion treatment such as R-Pro
supplied by SAMSUNG (Code: MOK-220SA) or
commercial water repellent grease and wax, etc.,
based on the product condition.
– When the product is to be shut down for a long
period of time, such as off-peak hours, take
appropriate measures like covering the product.
• If the product installed within 500m of seashore,
special anti-corrosion treatment is required.
further details.
Outdoor unit dimensions
A Type
AC071BXAPKG/AC071BXAPNG
940
B Type
AC100BXAPKG/AC100BXAPNG/AC120BXAPNG/AC140BXAPNG
940
(Unit: mm)
620
620