Backup Security - Bay Networks Remote Annex User Manual

Backup Security

When or If...
the maximum number of retries
(10 by default) is reached without
a response from the server,
no response is received from the
backup server,
an accounting fail-over occurs,
the server remains the same until,
both the accounting primary
server and backup fail,
If you configure port server, CLI, VCLI, and PPP security to use Windows
®
NT domain names and passwords, and the ACP security server is not
available, the Remote Annex uses its locally stored password parameters
to restrict user access. These parameters settings serve as backup
security.To use backup security, you must set the parameters listed in the
following table.
For: Back-up Security uses:
Port Server port_password
Incoming Port port_password
VCLI vcli_password
For additional sources of information about back-up security and
settings for these parameters, please refer to Document References
on page 1-6.
Remote Annex Server Tools for Windows NT
Chapter 4 Using Security Features
The...
attempt to authenticate against the
primary server fails and ERPCD/ACP
attempts to authenticate against the
backup server (if defined).
user is rejected.
failure of the backup server.
the acp_logfile records RADIUS
accounting.
®
User Guide
4-21