SCSI ID Numbers
There are four possible numbering schemes depending on whether you are
using 1-inch height drives, 1.6-inch height drives, simplex controller, or duplex
controllers. The following four figures illustrate these four schemes.
Figure 4-23.
IMPORTANT:
The Simplex Enable board must be installed on the back of
the drive cage for the simplex modes and the Duplex Enable board must be
installed for the duplex modes.
3
Not Used
2
1
0
SCSI ID numbers - Single SCSI Channel (Simplex Mode) with 1-inch drives
6
5
4
ProLiant 3000 Setup and Installation Guide
4-25