New Features And Changes In Release 6.1; Support For Communication Server 1000 Release 5.0 - Nortel 1000 Release Note

2

New Features and Changes in Release 6.1

Support for Communication Server 1000 Release 5.0

Please make sure that you record the image with recording software that
recognizes the ISO format. Your software will warn you if it does not
recognize the format.
Dragging the .iso image onto your CD-RW drive will result in creating an
invalid CD with just the CD-image file stored on it.
Put the recorded CD into the Application Gateway CD drive and reboot
the server by powering it on.
In about a minute after the server restarts, you should see information
about the progress of the installation through the serial console.
The following sections provide an overview to Release 6.1:
Support for Communication Server 1000 Release 5.0, page 5
Daylight Savings Time Changes, page 6
Application Gateway 2000, page 6
Licensing, page 7
Voice Office Applications, page 9
Smart Agent Integration with Outlook Contacts, page 10
Smart Agent Support for E.164-Compliant Phone Numbers, page 12
Smart Agent Support from Web and Windows Applications, page 13
Product Documentation, page 14
Sites using Communication Server 1000 Release 5.0 can now obtain
IP-to-DN mapping information from the signaling and call servers. You
configure a connection between the Application Gateway and one
signaling server, which provides the Application Gateway with
information from all connected call servers (even if there are two signaling
server). IP to DN synchronization creates a map of Phone IP addresses to
Phone primary DNs.
For information about configuring IP-to-DN mapping, refer to "Specifying
a Source for Phone IP-to-DN Mappings" in Chapter 4 of the Application
Gateway Administration Guide.
New Features and Changes in Release 6.1
Release Notes 5