Nortel Agent Greeting NTVQ09AB Maintenance And Troubleshooting Manual page 15

Table 2: HEX Display codes during bootup
Display Code VPS (NTVQ09AB) Definition
T:14 Programming CEMUX FPGA
T:15 Programming DSP FPGA
T:16 Testing CEMUX interface
T:17 Testing EEPROM
T:18 Booting 486, waiting for response
with self test information
T:19 Waiting for application start-up
message from 486
T:20 CardLAN enabled, waiting for
Request Config. Message
T:21 CardLAN operational, A07
enabled, display now under host
control
T:22 Not used at present
Note: The security dongle is required for normal Agent Greeting Card
operation. A keycode is supplied during installation, which is matched to
the dongle, and authorises a number of channels for use.
The Agent Greeting Card reports a missing dongle during boot up via a
message on the serial connection. Once a dongle is inserted, the serial number
is reported during boot up.
On Media Card Agent Greeting (NTVQ09BA), if the internal RAM test,
ALU test, address mode test, boot ROM test, timer test or external RAM test
fails, the pack goes into a maintenance loop as no further processing is
possible. If a test fails, "F:XX" appears on the hex display for three seconds
after the "T:13" message, with the "XX" indicating the test that failed. For
example, if the 8051 co-processor test failed, "F:05" is displayed. IF more
than one test fails, the message indicates the first failure.
Agent Greeting Card Test and Debug Capabilities
Agent Greeting Card Maintenance and Troubleshooting Guide
Media Card (NTVQ09BA)
Definition
Booting IXP1200, waiting for
response from selftest
information.
Not used at present
Not used at present
Not used at present
Not used at present
Not used at present
Waiting for application start-up
message from IXP1200
CardLAN enabled, waiting for
Request Config. Message
CardLAN operational, A07
enabled, display now under host
control
Page 21 of 66