Nortel Meridian Companionж Supplementary Manual page 13

C3050 registration instructions using the Administration Terminal Page 9 of 10
1. Follow steps 1 to 5 of "Measuring undirected RSSI" on page 7.
If the display shows the ID of a Base Station neighboring the one you
want to measure, proceed to step 2.
If the display shows the ID of the Base Station you want to measure,
move out of the cell boundary range so that hand-off occurs and then
continue with step 2.
2. Press . The display shows MENU.
Press " or ' until the display shows Feature request .
3.
4. Press SELCT . The display shows A- .
Press ° • ª ª .
5.
6. Enter the five-digit ID code for the Base Station radio you want to
measure. The display shows the cell number, the radio ID of the Base
Station to which the portable is linked, the power mode (high or low),
followed by the signal strength and the channel. For example,
8 15112 H 67 29.
You can also press ⁄ to view the information in "standard" display
mode. This mode displays the radio ID of the Base Station to which the
portable is linked, followed by the signal strength and power mode. For
example, 15112 - 67 H . You can revert back to the initial display mode
by pressing ƒ .
Hand-off does not occur as you move between the cell boundaries. The
link drops when you move out of range.
Note: In this example, the cell is 8, the card is 15, the port is 11, the
radio is 2, and the channel is 29. The signal strength measured
by the Base Station is -67 dBm, and the H indicates the portable
is transmitting in high-power mode (an L indicates low-power
mode).
To end the connection, press |or close the flap.
7.
Meridian Companion Portable Telephone Registration Instructions