Steps
1. Place the I/O daughter-board cable on the palm-rest and keyboard assembly.
NOTE:
To place the I/O daughter-board cable on the palm-rest and keyboard assembly, carefully slide the I/O
daughter-board cable underneath the wireless-antenna cables.
2. Connect the I/O daughter-board cable to the connector on the I/O daughter-board and close the latch.
3. Connect the I/O daughter-board cable to the connector on the system board and close the latch.
Next steps
1. Install the
system board thermal
NOTE:
This procedure applies only to computers shipped with a system board thermal plate installed.
2. Install the fan.
NOTE:
This procedure applies only to computers shipped with a fan installed.
3. Install the
base
cover.
4. Follow the procedure in
I/O daughter-board
Removing the I/O daughter-board
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
plate.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
65