3. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
4. Replace the four screws (M2.5x5) to secure the display hinges to the palm-rest and keyboard assembly.
5. Route the wireless-antenna cables through the routing guides on the palm-rest and keyboard assembly.
6. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
7. Connect the display cable and speaker cable to the respective connectors on the system board.
Next steps
1. Install the
wireless
card.
2. Install the
base
cover.
3. Follow the procedure in
Display hinge caps
Removing the display hinge caps
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
About this task
The following images indicate the location of the display hinge caps and provide a visual representation of the removal
procedure.
78
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.