I/O Daughter-Board Cable; Removing The I/O Daughter-Board Cable - Dell Inspiron 15 3530 Owner's Manual

Steps
1. Connect the touchpad FFC to the connector on the touchpad and close the latch.
2. Align and place the touchpad, along with the touchpad FFC, in the slot on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) to secure the touchpad to the palm-rest and keyboard assembly.
4. Place the touchpad bracket in the slot on the palm-rest and keyboard assembly.
5. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
6. Replace the three screws (M2x2) to secure the touchpad bracket to the palm-rest and keyboard assembly.
7. Connect the touchpad FFC to the connector on the system board and close the latch.
Next steps
1. Install the 3-cell battery
2. Install the base cover.
3. Follow the procedure in

I/O daughter-board cable

Removing the I/O daughter-board cable

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the fan.
NOTE: This procedure applies only to computers shipped with a fan installed.
4. Remove the system board thermal
NOTE: This procedure applies only to computers shipped with a system board thermal plate installed.
or the 4-cell battery, whichever applicable.
After working inside your
Before working inside your
plate.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 63