NOTE:
This step applies only to computers shipped with a fingerprint reader installed.
6. Connect the I/O daughter-board cable to the connector on the I/O daughter-board and close the latch.
7. Close the left display hinge downwards to align the screw holes on the left display hinge to the screw holes on the I/O
daughter-board and the palm-rest and keyboard assembly.
8. Replace the two screws (M2.5x5) to secure the left display hinge to the I/O daughter-board and the palm-rest and keyboard
assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power button
Removing the power button
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
I/O
daughter-board.
About this task
The following image indicates the location of the power button and provides a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x2) that secures the power button to the palm-rest and keyboard assembly.
2. Lift the power button off the palm-rest and keyboard assembly.
68
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.