Physical Installation
3.
Power up the projector.
4.
Go to Main Menu / Installation / Orientation and select the correct orientation for your setup.
5.
Go to Main Menu / Test Patterns and select an internal hatch pattern to display on the screen.
6.
Adjust the position (height and angle) of the rigging frame until the projected hatch pattern is a level and
perfect rectangle.
If applied in a motion rig, care must be taken to stay within the environmental specifications for
vibration and shock. It may also be necessary to use additional, custom means to stabilize the
projection lens to make sure that the projected image remains in position and properly focused.
4.6 Projector safe attachment points
About
Due to use of a Rigging Frame or other equipment, the projector has some defines anchor points that shall be
used. See the illustration below.
Note that there is only this 4 selected attachment points, in addition to the mounting holes for the feet that is
approved as anchor points for the unit.
Image 4–3
66
601–426 /15
F70 Series
1
Anchorpoints.
For attaching to rigging frame or similar.