Communication; Remote Control; Broadcast Address - Barco F70 Series User Manual

System settings menu

10.1 Communication

About
Settings / Communication / LAN
Network connection is required to communicate with the projector via LAN or Internet.
Current Ethernet communication information is given, and can be edited in this menu.
Default mode for Ethernet communications are: Automatic ON / IP Version 4 DHCP mode.
Setting
Automatic
ON
OFF
IP version 4
Static mode
DHCP mode
Image 10–2
Manually set up the IP adress
Go to the menu Settings / Communication / LAN
Enable the Auto zone on the display and press enter. The Auto zone will change to "Manual".
Scroll down, and modify the desired fields. When in the desired fields, press "Enter" to enable the virtual
keyboard, enter the desired values, and press "Enter" again to confirm the change.

10.2 Remote control

10.2.1 Broadcast address

About broadcast address
Broadcast address is a common address that can be set on the projector. That can be "0" or "1". The default
broadcast address is '0'.
Any command coming from an RCU programmed with that common address will be executed.
How to the broadcast address
1. In the main menu, select Settings → Communication → Remote control.
148 601–426 /15 F70 Series
Description
DHCP enabled
Static
Set address, subnet mask and default gateway according to network
specification.
Assigned IP address, subnet mask and gateway.