Table of Contents
Advertisement
16
Bugs fixed in release 2.0.7.8
•
DHCP can no longer be enabled on an interface which is not assigned an IP
address. (Q00093563-03))
•
DHCP parameters can not be set when DHCP is not enabled on an interface.
(Q00093563-03)
•
When DHCP is disabled, all the forwarding paths pertaining to that interface
are deleted. (Q00032689-03)
IP
This section describes the IP bugs that have been fixed in the Passport 1000 Series
switch software release 2.0.7.8.
•
A filter route entry for the same destination as an existing OSPF/static route
now gets added to the main routing table, once the OSPF/static route is
deleted. (Q00091868, Q00108739)
•
An IP filter route whose next-hop is reachable through a RIP-learned route
now comes up properly in the route table across a reboot. (Q00084324)
•
The default route 0.0.0.0 can now be created and deleted only with a mask
of 0. (Q00030843-01)
•
Announce policies now announce local routes which are created before the
announce policy is enabled. (Q00084321)
•
RIP or OSPF can no longer be enabled on an interface which does not have an
IP address. (Q00147252-04)
IPX
The following IPX bugs have been fixed in Passport 1000 Series routing switch
software release 2.0.7.8:
•
Inactive IPX static routes are now restored across reboots with ASCII config
files. (Q00170790)
•
The parameter
reboots with ASCII config files. (Q00157135)
•
An inactive static route no longer comes into the main routing table when IPX
forwarding is disabled and enabled, or if the switch is rebooted. (Q00084658)
•
An IPX static route can now no longer be created with a metric of 16 through
Device Manager. (Q00029863)
212629-A
learnafterincrement
is now saved properly across
Advertisement
Table of Contents
