Nortel Passport 1100 Release Note page 15

• A potential member of a policy based VLAN is now removed from the active
membership of the VLAN, if the port goes down. (Q00035785)
• Port members of a STG are now added as potential members of a policy-based
VLAN based on that STG, even if the same policy-based VLAN exists in
another STG. (Q00156752)
• A port can now be added as a
policy-based VLAN, only if the port is a member of the STG to which that
VLAN belongs. (Q00107771)
CLI
This section describes CLI bugs that have been fixed in the Passport 1000 Series
switch software release 2.0.7.8.
• The
show config
VLANs configured on the switch irrespective of their VLAN ID.
(Q00154660)
• The CLI command to add, delete and change the MD5 key for OSPF are now
supported only from the OSPF tree and no longer from the VLAN interface.
(Q00045400-02)
• When you attempt to delete a static route by specifying a different mask, the
following error message is now displayed:
Error: route tbl consistency check failed
Error: Cannot find route
(Q00030843-01)
• The range for valid values for IP traffic filter IDs is now displayed as 1-767.
(Q00091995-02)
DHCP
This section describes DHCP bugs that have been fixed in the Passport 1000
Series switch release 2.0.7.8.
• The Passport 1000 Series Switch now uses the ingress port information in the
source ip address
Release Notes for the Passport 1000 Series Software Release 2.0.7.8
not allowed to join member
CLI command now displays the information on all the
field of the DHCP request packet. (Q00208249)
Bugs fixed in release 2.0.7.8 15
of a