Table of Contents
Advertisement
0-10 VDC Signal Control
GJI model comes pre-wired from the factory for use with the speed dial / potentiometer control.
To utilize a 0-10 VDC control signal, disconnect the factory installed potentiometer wiring at the terminal strip. For
control signal, connect common wire to terminal GND and 0-10 VDC to terminal AN1.
Contact the factory for instructions on how to change the voltage.
Figure 7 – GJI 115V wiring diagram
Figure 8 – GJI 208-230/277V wiring diagram
6
GreenJet – Mixed Flow Jet Fan
®
Advertisement
Table of Contents
