Table of Contents
Advertisement
EUROPEAN CONTACT:*
Teledyne GmbH – LeCroy Division
Im Breitspiel 11c
D-69126 Heidelberg
Germany
Tel: (49) 6221 82700
Australia & New Zealand Declaration of Conformity - EMC
The probe complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by the Australian Communication and Media
Authority (ACMA):
AS/NZS CISPR 11:2009/A1:2010, EN 55011:2009/A1:2010 Radiated and Conducted Emissions,
Group 1, Class A.
AUSTRALIA / NEW ZEALAND CONTACTS:*
RS Components Pty Ltd.
Suite 326 The Parade West
Kent Town, South Australia 5067
* Visit teledynelecroy.com/support/contact for the latest contact information.
Safety Compliance
EC Declaration of Conformity – Low Voltage
The probe meets the intent of EC Directive 2014/35/EU for Product Safety.
Compliance was demonstrated to the following specifications as listed in the Official Journal of the
European Communities:
IEC/EN 61010-1:2010 + A1:2019 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 1: General requirements
IEC/EN 61010-2-032:2019 Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use – Part 2-032: Particular Requirements for Hand-Held and Hand Manipulated
Current Sensors for Electrical Test and Measurement.
Environmental Compliance
End-Of-Life Handling
The probe is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
The probe is subject to disposal and recycling regulations that vary by country and
region. Many countries prohibit the disposal of waste electronic equipment in standard
waste receptacles. For more information about proper disposal and recycling of your
Teledyne LeCroy product, visit teledynelecroy.com/recycle.
RS Components Ltd.
Unit 30 & 31 Warehouse World
761 Great South Road
Penrose, Auckland, New Zealand
Page 18
Advertisement
Table of Contents
