Table of Contents
Advertisement
15.1 Removing the intensity adjustment
unit.
TOP PREVIOUS NEXT
1. Cut off the insulated tie (medium) bundling the lead wire and gear box side sensor and the
insulated tie (small) bundling the lead wire of intensity sensor with the aid of a nipper.
2. Remove the up/down belt and intensity adjustment belt.
3. Remove the intensity unit connector (green) and intensity sensor connector (white).
4. Remove the intensity sensor set screw A, and remove the intensity sensor.
5. Remove the K type stop ring.
6. Remove the intensity unit set screws B and C.
7. Remove the fitting part, and withdraw.
*If the intensity sensor has not been removed from the intensity adjustment unit, the intensity
adjustment unit cannot be disassembled and assembled.
•@
TOP PREVIOUS NEXT
Advertisement
Table of Contents
