Table of Contents
Advertisement
13.2 Removing the massager
TOP PREVIOUS NEXT
1. Remove the two installation screws from the massager cover, and take off the cover.
2. Push down the seatback to the front part.
•Inspection and repair are done after placing the chair as explained in 1. and 2. above.
3. Remove the rail piece set screws (K4-6), 3 pieces (left and right) shown in Figure 9 , and
remove the rail pieces A and B.
4. When the massager moves up and down (normally), move it down to the lowest position by
setting the controller manual operation up/down button to "DOWN", and then turn clockwise
the up/down clutch hex nut M6 (see Figure 9) tomove to the position where the Pinion A and B
block is visible from the back frame.
*When the massager fails to move up and down, turn clockwise the hex nut M6 of up/down
clutch.
(The massager can be moved by attaching the hex socketø10 (for nut 6 mm) to a rechargeable
drill driver.)
5. Remove the three connectors (red, yellow, white, blue, brown) of the power connecting cord
connected to the massager, remove one screw (K4-6) fixing the massager side cord clip, and
remove the power connecting cord from the massager.
6. In this state the massager can be taken out.
Advertisement
Table of Contents
