Avaya VPNremote 4600 Series Administrator's Manual page 28

System Parameters Customization
Table 4: VPNremote for 4600 Series IP Telephones Customizable System
Parameters (continued)
Parameter Name
DROPCLEAR
VPNMONFRQ
ACTIVATEVPN
ALWSTOPVPN
VPNACTIVE
28 Administrator Guide
Default Value Description and Value Range
1 Controls the policy that defines the handling
on incoming and outgoing clear packets. Valid
value is one ASCII numeric digit, 0 and 1.
Values are:
0 =All clear traffic is accepted.
1 = All clear traffic will be dropped except for
traffic to and from the security gateway and
the DHCP server.
0
This value contains the frequency of VPN
monitoring syslog message in minutes.
0
This value is ignored if NVVPNMode is set to
1 or 0.
If the value is set to 1, the VPN tunnel setup
procedure is invoked prior to starting the
system specific procedures.
0
This value contains the policy that defines if
user is allowed to stop VPN while connected
to the call server. If this value is 1, the user is
allowed to stop the VPN connection.
The VPNACTIVE This value is read-only.
value is 1 when
the VPN tunnel is
active and 0
when the VPN
tunnel is not
active.
4 of 4