Table of Contents
Advertisement
Oct. 2017
Disassembly Procedure
1.
Remove the screws a (x 15) securing the Bottom Case.
(Plain View (1) (p. 8), View 1)
2.
Detach the Bottom Case.
Detaching the Platters
1.
Disconnect the connectors (1 each on the left and right) connected the
Sensor Board to the Panel Board.
2.
Remove the screws B (x 4) securing the Sensor Board
(Plain View (2) (p. 9), View 4).
3.
Insert the straight headed precision screwdriver into the hole of the E-
Ring (#5100058429) and hold it.
fig.kumitate-1.eps
4.
Press the E-Ring (#5100058429) out with the needle nose pliers and
remove it from the pipe.
fig.kumitate-2.eps
* Never reuse the E-Ring which has been removed once, replace it with new one.
5.
Remove the Platter Spacer (#5100058428).
6.
Hold down the pipe of the Platter and press it out toward to the Top
Case, then detach it.
10
Assembling the Platters
1.
Attach the Platter Spacer (#5100058428) to the pipe of the Platter.
2.
Apply grease (#17042117) to the pipe of the Platter.
fig.kumitate-5.eps
3.
Pass the platter through the hole in the Top Case.
4.
Verify that the tip of the pipe of the platter is coming out from the hole of
the platter and attach the Platter Spacer (#5100058428).
fig.kumitate-3.eps
5.
Fit the E-Ring (#5100058429) with the needle nose pliers.
fig.kumitate-4.eps
DJ-202
Advertisement
Table of Contents
