Table of Contents
Advertisement
WLM1200-RMTS™ User Guide
rm200a1 > en
rm200a1 # show ?
bootvar
Display installed system images and boot parameters
hosts
Display hostname, DNS configuration, and static host mappings
images
Display information about system images and boot parameters
interfaces
Display detailed running state for all interfaces
ip
Display IP-related information
log
View event logs
running-config
Display commands to recreate current running configuration
terminal
Display terminal parameters
version
Display version information for current system image
whoami
Display the identity and capabilities of the current user
Enable Mode
After you type enable or en at a rm200a1 > prompt, you see a rm200a1 # prompt:
Enable Mode Commands
rm200a1 # ?
configure
Enter configuration mode
disable
Leave enable mode
email
Configure email and event notification via email
exit
Log out of the CLI
help
View description of the interactive help system
image
Manipulate system software images
no
Negate or clear certain configuration options
ping
Send ICMP echo requests to a specified host
reload
Reboot or shut down the system
show
Display system configuration or statistics
terminal
Set terminal parameters
write
Save the running configuration to persistent storage
configure ? Command
rm200a1 # configure ?
terminal
Enter configuration mode
show clock Command
rm200a1 # show clock
Time: 23:30:21
Date: 2007/12/10
Time zone: GMT-offset GMT
configure terminal Command
rm200a1 # configure terminal
rm200a1 (config) # show ?
bootvar
Display installed system images and boot parameters
hosts
Display hostname, DNS configuration, and static host mappings
images
Display information about system images and boot parameters
interfaces
Display detailed running state for all interfaces
ip
Display IP-related information
log
View event logs
running-config
Display commands to recreate current running configuration
terminal
Display terminal parameters
version
Display version information for current system image
whoami
Display the identity and capabilities of the current user
rm200a1 # email ?
send-test
Send test email to all configured event and failure recipients
8
Using The Command Line Interface
Copyright © 2011, Juniper Networks, Inc.
Advertisement
Table of Contents
