Table of Contents
Advertisement
WLM1200-RMTS™ User Guide
-------------------------------------------------------------------
Use the ^ and v keys to select which entry is highlighted.
Press 'b' to boot, 'e' to edit the selected command in the
boot sequence, 'c' for a command-line, 'o' to open a new line
after ('O' for before) the selected line, 'd' to remove the
selected line, or escape to go back to the main menu.
Highlighted entry is 1:
It should be noted that two 'console' options appear on the kernel line. In this example, the latter is the
serial console and the former is the direct console. The console option that appears last is used. If the
procedure is used on the direct console, the order of the two console options should be changed or the
serial one (console=ttyS0,9600n8) should be deleted.
6. When done editing the kernel line, press the <enter> key followed by the b key to resume booting the
selected image. After more boot messages a root user prompt will be displayed:
sh-2.05b#
7. At this prompt, run the following command:
/sbin/resetpw.sh
If successful, the admin password is now reset to an empty password. If any corruption of configuration
state is detected, an attempt to save existing configuration databases is made and the system's
configuration state is reset to initial values — i.e. the same state as when the system was manufactured.
In this case, the admin password will be set to the 'empty' password. The command will notify you of any
locations of saved configuration state.
sh-2.05b# /sbin/resetpw.sh
Admin password reset successful.
sh-2.05b#
8. The system can now be restarted by issuing the command reboot at the command prompt.
sh-2.05b# reboot
Web Interface
The platform configuration Web interface available on port 8003 provides the functionality described in the
paragraphs below. After you have used the wizard to set up the WLM1200-RMTS's IP address, either
manually assigned or assigned via DHCP, you can use the CLI to verify it, and then access this address
using a browser.
To determine the IP address after it is assigned using DHCP, use the CLI command:
rm200a1 # show interfaces
Interface eth0 state
Admin up:
yes
Link up:
yes
IP address:
172.21.26.231
Netmask:
255.255.255.0
Speed:
100Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
MTU:
1500
HW address:
00:30:48:33:43:E6
12
Web Interface
Copyright © 2011, Juniper Networks, Inc.
Advertisement
Table of Contents
