Table of Contents
Advertisement
Installing options in the control enclosure
|
|
|
|
5. Reinstall the left and right end caps as shown in Figure 11 on page 16. The left
end cap has indicator windows that align with the status LEDs (light-emitting
diodes) on the edge of the enclosure.
a. Ensure that the serial number of the end cap matches the serial number on
the rear of the enclosure.
b. Fit the slot on the top of the end cap over the tab on the chassis flange.
c. Rotate the end cap down until it snaps into place.
d. Ensure that the inside surface of the end cap is flush with the chassis.
If you have purchased host interface cards or cache memory upgrades for your
control enclosure and those options were not preinstalled for you, you must open
each node canister and install the options.
Note: You must install the same options in all node canisters.
First, open the canister as described in "Opening the node canister" on page 18.
Then refer to the procedure for the option you are installing:
v "Installing an 8 Gbps Fibre Channel 4-port host interface card" on page 20
v "Installing a 10 Gbps iSCSI-FCoE 2-port host interface card" on page 22
v "Installing a 1 Gbps iSCSI 4-port host interface card" on page 25
v "Installing a SAS 4-port host interface card" on page 26
v "Installing an 8 GB cache memory upgrade" on page 28
Finally, close the canister and install it in the control enclosure (see "Closing the
node canister" on page 30).
Note: Disk drives can also be installed in the control enclosure, but that procedure
does not involve opening any node canisters. See "Installing disk drives" on page
32 for details.
Chapter 2. Installing the hardware
17
Advertisement
Table of Contents
