Table of Contents
Advertisement
operation Massage head adjustment button to DOWN.
2. Install a washer and a spring to the guide roller G in the left side
and mount the massager on the lowest position of the back frame.
3. Turn the hex nut M6 counterclockwise and move the massager
upward.
4. Make sure that the massager has been mounted horizontally by
moving the massager to the position shown in the Figure.
*Unless the massager has been mounted horizontally, an
abnormal sound or problem may occur.
5. Move it up to the highest position (until the massager stops) by
setting the controller manual operation Massage head adjustment
button to up.
6. Peeping into the square hole of the back frame, check the position
of the massager to adjust.
*One thread of the up/down detection gear gives a stroke change
of 4mm.
When the massager has been raised excessively : Turn the up/down detection gear
counterclockwise to adjust.
When the massager has been lowered excessively : Turn the up/down detection gear clockwise
to adjust.
While adjusting the distance between the square hole and Guide
roller assy. to 10mm, check by using the up/down adjustment
button found on the manual operation panel of the controller.
7. Install the rail piece A and B, and tighten uniformly the set screws
(left and right, 3 pcs. each).
8. Using the manual operation of the controller, conduct the rolling
PDF created with pdfFactory Pro trial version
23
www.pdffactory.com
Advertisement
Table of Contents
