Epson SC-P600 Service Manual page 41

SC-P600
2. Install the printer on a level workbench.
Place the printer on a level, warp-free table. This adjustment cannot be performed correctly if
it is performed on a warped table.
3. Set the PF Roller Adjustment Jig to the PF Roller Adjustment Jig Stand show in
Figure 2-3. Setting the PF Roller Adjustment Jig to the PF Roller Adjustment Jig Stand
4. Perform zero adjustment.

Long hand position: Turn the dial to adjust the "0" position on the scale to the long hand position with the jig set in

Short hand position: Check it.
Adjustment
place on the PF Roller Adjustment Jig Stand.
Figure 2-4. Perform zero adjustment
Details of Adjustments
Confirm the fixing with rubber of jig.
The length can be changed by adjusting the bolts.
0 position
SE Group Confidential (Related Staff Only)
Revision D
Figure 2-3.
41