Table of Contents
Advertisement
IBM PCI WAN MultiPort T1/E1 S94 and
IBM PCI WAN MultiPort T1/E1 P92
The green LED adjacent to each port on the IBM PCI
WAN MultiPort T1/E1 S94 and the IBM PCI WAN
MultiPort T1/E1 P92 (see Figure 2 at right) provides a
convenient indication of the status of the connection on
that port.
Explanations for the different LED states can be found
in Table 1 below.
LED State
Connection Status
Off
The port is not loaded (the configuration
file describing protocol and interface
parameters has not been read by the
device driver on the PC).
Rapid Flash
The connection has not been established.
(stays on for
Either the port is loading, OR there is no
1/2 second)
response from the destination device,
OR the WAN Adapter is waiting for a
VHSI cable to be connected to the port.
Slow Flash
The connection was interrupted
(stays on for
unexpectedly. The cable was unplugged
1 second)
or damaged while a connection was
active.
On
The port is active and the connection
is good.
Table 1: LED States
5
Figure 2: End Bracket
Remedy
Consult your networking software
for instructions on how to load a
configuration file and how to start a
connection.
Verify that the cable is properly
connected to the port. If the light
continues flashing after a few
minutes, verify that the destination
device is active.
Reconnect the cable.
Connection Status Indicators
LED 1
Port 1
LED 2
Port 2
Advertisement
Table of Contents
