Making An Isdn Connection - IBM PCI WAN 2 Port S91 Installation Manual

Making an ISDN Connection

IBM PCI WAN 2 Port S91 only
Locate the ISDN cable included with the IBM PCI WAN 2 Port S91.
• In Europe, connect one end of the cable to the ISDN port, and connect the
other end to the wall jack installed by your ISDN service provider.
Locate the RJ-45 to RJ-11 cable included with the card. Plug the RJ-45 end
into the ISDN port on the card, and plug the RJ-11 end into the wall jack.
These connections are shown in Figure 4 below.
Note The RJ-11 plug will also fit into an RJ-45 jack.
• In North America and Australia, a network termination device (NT1) is
required. Connect one end of the ISDN cable to the WAN Adapter, and
connect the other end to the S/T interface connector on your NT1. Connect
one end of the cable provided with your NT1 to its U interface connector, and
connect the other end to the wall jack installed by your ISDN service provider.
These connections are shown in Figure 5 below.
Figure 4: Connecting to an ISDN jack
NT1 Device
U Interface S/T Interface
ISDN Jack
Figure 5: Connecting through an NT1 Device
7 Making an ISDN Connection