Fieldbus Connections; Model Code; Non-Intrinsically Safe Wiring - Emerson Rosemount 5600 Series Reference Manual

Reference Manual
00809-0100-4025, Rev AA
May 2003

Fieldbus Connections

Model Code

Figure 3-1. Example of a
fieldbus label
Non-Intrinsically Safe
Wiring
Figure 3-2. Transmitter Terminal
Block (Non-IS Wiring)
For best installation practices use a fieldbus type A cable. Do not run
unshielded signal wiring in conduit or open trays with power wiring or near
heavy electrical equipment. Do not remove the transmitter cover in explosive
atmospheres when the circuit is alive. Use ordinary copper wire of sufficient
size to ensure that the voltage across the fieldbus terminals does not go below 9
V dc.
NOTE
Do not apply high voltage (e.g. ac line voltage) to the fieldbus terminals.
Abnormally high voltage can damage the unit.
Use the Model Code located on your fieldbus transmitter to determine wiring
connection. Refer to document number 00809-0100-4024 Appendix A:
Reference Information for detailed descriptions regarding all Rosemount 5600
model codes.
5601 UE5P7A0NE
NOTE:
1-2= BUS Connection
3-4 =Power Connections
A= Ground Terminal
Rosemount 5600 Series
A
X1
3-3