Advertisement
Hanging the Fan
to turn off the power. Follow the
REMEMBER
steps below to hang your fan properly:
CAUTION
Remove the 5 screws from the motor support plate,
discard the 5 screws and motor support plate.
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 5)
Step 2. Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket
the screw head and turning the canopy counter
clockwise.(Fig, 5)
Step 3. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 6.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and washers
provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor assembly.
Step 6. Route wires exiting from the top of the
fan motor through the collar cover, canopy
cover, canopy and then through the ball /
downrod. (Fig. 7)
Step 7. Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing. Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin
against the wiring inside the downrod. Insert
the locking pin through the hole near the end
of the hanger pin until it snaps into its locked
position. (Fig.7)
FAILURE TO PROPERLY INSTALL LOCKING PIN
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Step 8. Tighten two set screws on top of the fan
a half turn
from
motor firmly (Figure 7)
Step 9. Place the downrod ball into the hanger
bracket socket.
Figure 5
WARNING
Hanger
bracket
Ceiling
canopy
Canopy
cover
UL Listed
electrial
box
Ceiling
mounting
plate
Hook
120V Wires
Figure 6
Motor wires
Ball/downrod
assembly
Collar cover
Hanger pin
Figure 7
Washers
Mounting
screws
(supplied with
electrical box)
Downrod
Canopy
Canopy cover
Set screws
Locking pin
4.
Advertisement
