Troubleshooting; No Lights Are Lit On The Access Point - NETGEAR WAG102 Reference Manual

Prosafe dual band wireless access point

Hide thumbs Also See for WAG102:

Reference manual (102 pages)

Installation manual (2 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

This chapter provides information about troubleshooting your WAG102 ProSafe Dual Band

Wireless Access Point. After each problem description, instructions are given to help you diagnose

and solve the problem. For the common problems listed, go to the section indicated.

•

Is the WAG102 on?

•

Have I connected the wireless access point correctly?

Go to

"Installing the WAG102 Access Point" on page

•

I cannot remember the wireless access point's configuration password.

Go to

"Changing the Administrator Password" on page

Note: For up-to-date WAG102 installation details and troubleshooting guidance visit

http://kbserver.netgear.com/products/WAG102.asp.

If you have trouble setting up your WAG102, check the tips below.

No lights are lit on the access point.

It takes a few seconds for the power indicator to light up. Wait a minute and check the power light

status on the access point.

If the access point has no power.

•

Make sure the power cord is connected to the access point.

•

Make sure the power adapter is connected to a functioning power outlet. If it is in a power

strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it

is not a switched outlet.

•

Make sure you are using the correct NETGEAR power adapter supplied with your access

point.