NETGEAR WAG102 Reference Manual page 32

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
4. Click the Wireless Settings 11b/g link in the Setup section of the main menu to view the
Wireless Settings 11b/g menu.
Figure 3-6
5. Configure the wireless interface for wireless access. See the online help or the
Basic Wireless Settings
Note: You must set the Regulatory Domain. It may not be legal to operate the
wireless access point in a region other than one of those identified in this field.
Now that you have finished the setup steps, you are ready to deploy the WAG102 in your
network. If needed, you can now reconfigure the computer you used in step 1 back to its
original TCP/IP settings.
6. Deploy the WAG102 Access Point
a. Disconnect the WAG102 and position it where you will deploy it. The best location is
elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
b. Lift the antenna on either side so that they are vertical.
Note: Consult the antenna positioning and wireless mode configuration information in the
Chapter 5, "Advanced Configuration"
3-10
topic of this Reference Manual for full instructions.
chapter of the Reference Manual.
v1.0, September 2005
Understanding
Basic Installation and Configuration