Storage Central Turbo Model SC101T and Storage Central Model SC101 User Manual
Installing the Storage Central Turbo SC101T Hardware
First prepare for installation as described in
"Preparing for Installation" on page
2-1. Then, install
a hard disk, and connect the Storage Central to your network. When you finish the installation,
your network will resemble this illustration.
Figure 2-4
Installing a Disk and Connecting the SC101T
Warning: To avoid damaging your hard disks, make sure that the Storage Central is
turned off or the power cord is unplugged before you add or remove the disks.
The instructions below explain how to install a single disk into your Storage Central Turbo
SC101T. Repeat these steps to install a second disk.
Note: Storage Central units format hard disks differently than a PC does. Do not swap
hard disks between Storage Central units and a PC: the data will be unreadable.
2-5
v1.0, December 2006